■:VSKLYPUN:WLJPÄJH[PVUZ

⑴Manual Soldering

Device

： Soldering iron

380

℃, Max.; 3 seconds, Max.

⑵Auto Soldering

Device

： Jet wave type or dip type

275

℃, Max.; 6 seconds, Max.

●Pre-heating should be done at temperatures ranging from 80℃

to 120

℃ and within 120 seconds

⑶Install the cap/rocker accessory after soldering and cleaning.

■Flux Cleaning

⑴Solvent : Fluorine or Alcohol type.

⑵Cleaning after soldering should be done after the terminal

temperature falls to 90

℃ or below, or after leaving the switch

MVY Ä]L TPU\[LZ VY SVUNLY H[ YVVT [LTWLYH[\YL

■Mounting of Switch

●Use PC boards with hole diameter of 1mm.

●Do not bend the terminal pins before mounting the switch on

the PC board.

●After mounting the switch, do not place the device in such a

way that the device weight will be applied on to the actuator of

the switch.

●Do not apply load exceeding 12.7 N to the actuator.

■7HJRHNPUN :WLJPÄJH[PVUZ

Plastick Pack

PC terminals

: 100 pcs/pack

Right angle terminals

: 50 pcs/pack

Plastick Pack

Vertical mounting terminals

100 pcs/pack

ATE