UCD3138064RMHT datasheet(44/91 Pages) TI1

44 / 91 page

UCD3138064

SLUSB72B – MARCH 2013 – REVISED SEPTEMBER 2014

www.ti.com

The brownout threshold is higher than the reset threshold voltage; therefore, when the supply voltage is

lower than brownout threshold, it still does not necessarily trigger a device reset.

The brownout interrupt flag can be polled or alternatively can trigger an interrupt to service such case by

an interrupt service routine. Please see the Section 5.8.

6.3.12 Global I/O

Up to 32 pins in UCD3138x can be configured in the Global I/O register to serve as a general purpose

input or output pins (GPIO). This includes all digital input or output pins except for the RESET pin.

The pins that cannot be configured as GPIO pins are the supply pins, ground pins, ADC-12 analog input

pins, EADC analog input pins and the RESET pin. Additional digital pins not listed in this register can be

configured through their local configuration registers.

There are two ways to configure and use the digital pins as GPIO pins:

1. Through the centralized Global I/O control registers.

2. Through the distributed control registers in the specific peripheral that shares it pins with the standard

GPIO functionality.

The Global I/O registers offer full control of:

1. Configuring each pin as a GPIO.

2. Setting each pin as input or output.

3. Reading the pin’s logic state, if it is configured as an input pin.

4. Setting the logic state of the pin, if it is configured as an output pin.

5. Connecting pin/pins to high rail through internal push/pull drivers or external pull up resistors.

The Global I/O registers include Global I/O EN register, Global I/O OE Register, Global I/O Open Drain

Control Register, Global I/O Value Register and Global I/O Read Register.

The following is showing the format of Global I/O EN Register (GLBIOEN) as an example:

BIT NUMBER

31:0

Bit Name

GLOBAL_IO_EN

Access

R/W

Default

0000_0000_0000_0000_0000_0000_0000_0000

Bits 29-0: GLOBAL_IO_EN – This register enables the global control of digital I/O pins

0 = Control of IO is done by the functional block assigned to the IO (Default)

1 = Control of IO is done by Global IO registers.

PIN NUMBER

BIT

PIN_NAME

UCD3138x

PWM2

PWM3

FAULT3

ADC_EXT_TRIG

TCK

TDO

TMS

TDI

SCI_TX1

SCI_TX0

SCI_RX1

SCI_RX0

TCAP0

Detailed Description

Submit Documentation Feedback

Product Folder Links: UCD3138064

UCD3138064RMHT Folha de dados(PDF) 44 Page - Texas Instruments

UCD3138064RMHT Folha de dados(HTML) 44 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91

Folha de dados Download

Ligação URL