LF205-PSLASHSP1 datasheet(2/2 Pages) LEM

2 / 2 page

Remarks

• I

S is positive when IP flows in the direction of the arrow.

• Temperature of the primary conductor should not exceed

100°C.

• Dynamic performances (di/dt and response time) are best

with a single bar completely filling the primary hole.

• Mounting clips molded into the transducer housing, attach to

printed circuit board 1.6mm thick.

Mechanical characteristics

• General tolerance

± 0.2 mm

• Fastening & secondary connection 3 pins 0.63x0.56 mm

Recommanded PCB hole

∅ 0.9 mm

• Primary through-hole

∅ 15.5 mm

• Supplementary fastening

2 holes

∅ 1.75 mm

Recommended PCB hole

2.4 mm

Recommended screws

KA22 x 6

LEM code

47.30.60.006.0

Dimensions LF 205-P/SP1 (in mm. 1 mm = 0.0394 inch)

Bottom view

Top view

LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.

Front view

Back view

Left view

Recommended dimensions

for mounting holes when

using the mounting clips.

Secondary terminals

Terminal +

: supply voltage + 12 .. 15 V

Terminal M : measure

Terminal -

: supply voltage - 12 .. 15 V

Connection

LF205-P/SP1 Folha de dados(PDF) 2 Page - LEM

LF205-P/SP1 Folha de dados(HTML) 2 Page - LEM

Html Pages

1 2

Folha de dados Download

Ligação URL