UT54ACTS220 datasheet(2/12 Pages) AEROFLEX

2 / 12 page

PIN DESCRIPTION

FUNCTIONAL TIMING: Single S

μMMIT Wait-State

For both read and write memory cycles, DTACK is an input to the S

μMMIT E and SμMMIT LXE/DXE. A non-wait state memory

requires two clock cycles, T1 and T2 of figure 1. For accessing slower memory devices, the UT54ACTS220 holds DTACK to a log-

ical “1”. This results in the stretching of memory cycles by one clock to three clock cycles, TW of figure 1. The SμMMIT E and

μMMIT LXE/DXE samples the DTACK on the rising edge of the 24 MHz clock. If DTACK is not generated before the rising

edge of the clock, the S

μMMIT E and SμMMIT LXE/DXE extends the memory cycle.

Pin Number

Pin Name

Description

CLKOUT

Buffered version of CLKIN.

CLKOUT

Inverted version of CLKIN.

CLKIN

Clock Input. This signal can be any arbitrary signal that the user wishes to buffer.

48MHz

48MHz Clock. The 24MHz clock is created by dividing this signal by two.

DMACK

DMA Acknowledge. This input is generated by the S

μMMIT. When high, this signal will

cause DTACK output to be forced high.

RCS

RAM Chip Select. This input is generated by the S

μMMIT.

MRST

Master Reset. This input can be used to preset 24MHz, DTACK and TEST. For normal

operation tie MRST to VDD through a resistor.

TEST

Test output signal.

DTACK

Data Transfer Acknowledge. This signal can be used to drive the DTACK signal of the

μMMIT if the user requires one wait state during the memory transfer.

24MHz

24MHz Clock. This output runs at half the frequency of the 48MHz input. The falling

edge of 24MHz is the signal that latches the DTACK outputs. 24MHz is forced high

whenever MRST is low. Properly loaded, 24MHz will have a 50% duty cycle

± 5%.

48MHz

24MHz

DMACK

RCS

DTACK

Figure 1. Functional Timing

UT54ACTS220 Folha de dados(PDF) 2 Page - Aeroflex Circuit Technology

UT54ACTS220 Folha de dados(HTML) 2 Page - Aeroflex Circuit Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

Folha de dados Download

Ligação URL