UM1865 datasheet(7/132 Pages) STMICROELECTRONICS

7 / 132 page

DocID027514 Rev 1

7/132

UM1865

Overview

132

Overview

Bluetooth LE technology was adopted by the Bluetooth SIG starting from the Bluetooth core

specification v4.1. Bluetooth LE technology was designed to enable products that require

lower power consumption, lower complexity and lower cost compared to the Bluetooth

classic or Bluetooth high-speed systems.

A typical BLE system consists of an LE controller and a host. The LE controller consists of a

physical layer (PHY) including the radio, a link layer (LL) and a standard host controller

interface (HCI). The host consists of a HCI and other higher protocol layers, e.g. L2CAP,

SM, ATT/GATT, GAP etc.

In many designs the LE controller and the host reside in two separate silicon chips and are

controlled by 2 different microcontrollers. Communication between the two is transmitted via

a hardware connection, e.g. UART, SPI, USB, etc. The host can send HCI commands to

control the LE controller. The HCI interface and the HCI commands are standardized by the

Bluetooth core specification. Please refer to the official document for more information.

The HCI interface provides a significant benefit. Any Bluetooth tester can easily connect to

the controller via the hardware connection, e.g. SPI, to test the controller by sending HCI

commands. This removes the need to involve the host if the only interest is to test the

controller.

Figure 1. Bluetooth LE system with separate host and controller

Sometimes the LE controller and the host can be combined into a single chipset solution.

This lowers the cost of hardware, first because it reduces the number of silicon chips to one

rather than two, and second because the hardware connection between the host and the

controller is no longer required.

Under this scenario, the host may directly control the LL/PHY. In this way, there is no need

to generate the standard HCI commands, transmit the commands to the LL, and then

process them. As a result, the execution time is improved and the calculation load on the

CPU is reduced. However, if the HCI is removed completely, it will be more difficult to test

only the controller with an external Bluetooth tester.

UM1865 Folha de dados(PDF) 7 Page - STMicroelectronics