UM0971 datasheet(7/45 Pages) STMICROELECTRONICS

7 / 45 page

UM0971

STEVAL-IHM031V1 features

Doc ID 17701 Rev 1

7/45

1.3.2

Demonstration board intended use

The STEVAL-IHM031V1 demonstration board is a component designed for demonstration

purposes only, and is not to be used for electrical installation or machinery. The technical

data as well as information concerning the power supply conditions must be taken from the

relevant documentation and strictly observed.

1.3.3

Demonstration board installation

The installation and cooling of the demonstration board is in accordance with the

specifications and the targeted application.

●

The motor drive converters are protected against excessive strain. In particular, no

components are to be bent, or isolating distances altered, during the course of

transportation or handling.

●

No contact must be made with other electronic components and contacts.

●

The boards contain electrostatically sensitive components that are prone to damage

through improper use. Electrical components must not be mechanically damaged or

destroyed (to avoid potential health risks).

1.3.4

Electronic connections

Applicable national accident prevention rules must be followed when working on the main

power supply with a motor drive. The electrical installation is completed in accordance with

the appropriate requirements (e.g., cross-sectional areas of conductors, fusing, PE

connections, etc.).

1.3.5

Demonstration board operation

A system architecture which supplies power to the STEVAL-IHM031V1 demonstration board

is equipped with additional control and protective devices in accordance with the applicable

safety requirements (e.g., compliance with technical equipment and accident prevention

rules).

Warning:

Do not touch the demonstration board after disconnection

from the voltage supply, as several parts and power terminals

which contain possibly energized capacitors need to be

allowed to discharge.

UM0971 Folha de dados(PDF) 7 Page - STMicroelectronics