AN2983 datasheet(9/32 Pages) STMICROELECTRONICS

Nome de Peças	AN2983

Descrição Electrónicos	Constant current inverse buck LED driver using L6562A

PDF	32 Pages

Scroll/Zoom	100%

Fabricante Electrônico	STMICROELECTRONICS [STMicroelectronics]

Página de início	http://www.st.com

Logo

9 / 32 page

AN2983

Circuit description

Doc ID 15679 Rev 1

9/32

The falling edge of the gate driver starts the toff delay (see Section 2.3 on page 9). At the

end of the toff delay the set input of the FF is activated and a new cycle begins.

Figure 7.

Simulated waveforms

2.3

FOT (fixed off time) delay circuit

Figure 8.

FOT net

The fixed off time delay circuit is implemented by connecting the gate drive (GD) output to

the ZCD input by means of a diode D5 in series with R11 and C7 (in parallel), and ZCD to

ground with R18 and C8 in parallel.

There is a clamp circuit behind the ZCD pin of the controller that limits the maximum voltage

to 5.7 V, and a comparator whose output goes high if the input voltage falls below the

threshold level of 0.7 V.

Hence when GD is high (10 V nominal), ZCD is forced to the clamp level of 5.7 V, but as

soon as the gate driver goes low, the diode D5 turns off and the capacitor C8 discharges

through R18 until the voltage reaches 0.7 V.

At this point the comparator switches on and triggers the set input of the flip-flop, whose

output goes high.

AN2983 Folha de dados(PDF) 9 Page - STMicroelectronics