EM357 Mini Modules

Page 13

This document is subject to change without notice

Document No: 0011-00-07-00-000 (Issue H)

AGENCY CERTIFICATIONS

The following Part Numbers are Certified as shown below:

Part Number

Certifications

Antenna

ZICM357SP0-1

FCC, IC, CE

PCB

ZICM357SP2-1

FCC, IC

PCB

ZICM357SP2-1C

FCC, IC

Nearson S181AH-2450S

FCC Compliance Statement Part 15.19, Section 7.15 of RSS-GEN

This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS Standards.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.

L'exploitation est autorisée aux deux conditions suivantes:

1. l'appareil ne doit pas produire de brouillage, et

2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d'en compromettre le fonctionnement.

Warning (Part 15.21)

Changes or modifications not expressly approved by CEL could void the user's authority to operate the equipment.

20cm Separation Distance

TocomplywithFCC/ICRFexposurelimitsforgeneralpopulation/uncontrolledexposure,theantenna(s)usedforthis

transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be

co-located or operated in conjunction with any other antenna or transmitter.

OEM Responsibility to the FCC and IC Rules and Regulations

The MeshConnect Mini Module has been certified per FCC Part 15 Rules and to Industry Canada license-

exempt RSS Standards for integration into products without further testing or certification. To fulfill the FCC and

IC Certification requirements, the OEM of the MeshConnect Module must ensure that the information provided

on the MeshConnect label is placed on the outside of the final product. The MeshConnect Mini Module is labeled

with its own FCC ID Number and IC ID Number. If the FCC ID and the IC ID are not visible when the module is

installed inside another device, then the outside of the device into which the module is installed must also display

a label referring to the enclosed module. The exterior label can use wording such as the following:

“Contains Transmitter Module FCC ID: W7Z-ZICM357SP0” or “Contains FCC ID: W7Z-ZICM357SP0”

“Contains Transmitter Module IC: 8254A-ZICM357SP0" or "Contains IC: 8254A-ZICM357SP0”

or

“Contains Transmitter Module FCC ID: W7Z-ZICM357SP2” or “Contains FCC ID: W7Z-ZICM357SP2”

“Contains Transmitter Module IC: 8254A-ZICM357SP2" or "Contains IC: 8254A-ZICM357SP2”

The OEM of the MeshConnect Mini Module may only use the approved antennas (PCB Trace Antenna and

external antenna (part number: S181AH-2450S)) that have been certified with this module. The OEM of the

MeshConnect Mini Module must test their final product configuration to comply with Unintentional Radiator Limits

before declaring FCC Compliance per Part 15 of the FCC Rules.