M51995AFP datasheet(26/43 Pages) RENESAS

26 / 43 page

M51995AP/AFP

REJ03D0835-0300 Rev.3.00 Jun 06, 2008

Page 24 of 40

Supply Voltage VCC (V)

2.0

1.5

1.0

0.5

Figure 14 ICC vs. VCC in Timer-off Duration of Intermittent Action Circuit

Voltage Detector Circuit (DET) Section

The DET terminal can be used to control the output voltage which is determined by the winding ratio of fly back

transformer in fly-back system or in case of common ground circuit of primary and secondary in feed forward system.

The circuit diagram is quite similar to that of shunt regulator type 431 as shown in figure 15. As well known from

figure 15 and figure 16, the output of OP AMP has the current-sink ability, when the DET terminal voltage is higher

than 2.5 V but it becomes high impedance state when lower than 2.5 V DET terminal and F/B terminal have inverting

phase characteristics each other, so it is recommended to connect the resistor and capacitor in series between them for

phase compensation. It is very important, one can not connect by resistor directly as there is the voltage difference

between them and the capacitor has the DC stopper function.

≈ 7.1 V

DET

5.4 k

10.8 k

1.2 k

F/B

6 S

3 k

500

Ω

1 S

10 S

Figure 15 Equivalent Circuit Diagram of Voltage Detector

M51995AFP Folha de dados(PDF) 26 Page - Renesas Technology Corp