PIC16F883-ESLASHSO. datasheet(211/338 Pages) MICROCHIP

211 / 338 page

 2006-2012 Microchip Technology Inc.

DS41291G-page 211

PIC16F882/883/884/886/887

13.4.16.3

Bus Collision During a Stop

Condition

Bus collision occurs during a Stop condition if:

After the SDA pin has been de-asserted and

allowed to float high, SDA is sampled low after

the BRG has timed out.

After the SCL pin is de-asserted, SCL is

sampled low before SDA goes high.

The Stop condition begins with SDA asserted low.

When SDA is sampled low, the SCL pin is allowed to

float. When the pin is sampled high (clock arbitration),

the Baud Rate Generator is loaded with SSPADD<6:0>

and counts down to 0. After the BRG times out, SDA is

sampled. If SDA is sampled low, a bus collision has

occurred. This is due to another master attempting to

drive a data ‘0’ (Figure 13-26). If the SCL pin is sam-

pled low before SDA is allowed to float high, a bus col-

lision occurs. This is another case of another master

attempting to drive a data ‘0’ (Figure 13-27).

FIGURE 13-26:

BUS COLLISION DURING A STOP CONDITION (CASE 1)

FIGURE 13-27:

BUS COLLISION DURING A STOP CONDITION (CASE 2)

SDA

SCL

BCLIF

PEN

SSPIF

TBRG

SDA asserted low

SDA sampled

low after TBRG,

set BCLIF

‘

0’

‘

0’

SDA

SCL

BCLIF

PEN

SSPIF

TBRG

Assert SDA

SCL goes low before SDA goes high,

set BCLIF

‘

0’

‘

0’

PIC16F883-E/SO. Folha de dados(PDF) 211 Page - Microchip Technology

PIC16F883-E/SO. Folha de dados(HTML) 211 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Folha de dados Download

Ligação URL