WM8946ECSSLASHR datasheet(72/175 Pages) WOLFSON

72 / 175 page

WM8946

Production Data

PD, July 2012, Rev 4.3

In Left Justified mode, the MSB is available on the first rising edge of BCLK following a LRCLK

transition. The other bits up to the LSB are then transmitted in order. Depending on word length,

BCLK frequency and sample rate, there may be unused BCLK cycles before each LRCLK transition.

Figure 23 Left Justified Audio Interface (assuming n-bit word length)

In I

2S mode, the MSB is available on the second rising edge of BCLK following a LRCLK transition.

The other bits up to the LSB are then transmitted in order. Depending on word length, BCLK

frequency and sample rate, there may be unused BCLK cycles between the LSB of one sample and

the MSB of the next.

Figure 24 I

2S Justified Audio Interface (assuming n-bit word length)

In DSP/PCM mode, the left channel MSB is available on either the 1

st (mode B) or 2nd (mode A) rising

edge of BCLK (selected by LRCLK_INV) following a rising edge of LRCLK. Right channel data

immediately follows left channel data. Depending on word length, BCLK frequency and sample rate,

there may be unused BCLK cycles between the LSB of the right channel data and the next sample.

In device master mode, the LRCLK output resembles the frame pulse shown in Figure 25 and Figure

26. In device slave mode, Figure 27 and Figure 28, it is possible to use any length of frame pulse less

than 1/fs, providing the falling edge of the frame pulse occurs greater than one BCLK period before

the rising edge of the next frame pulse.

Figure 25 DSP/PCM Mode Audio Interface (mode A, LRCLK_INV=0, Master)

WM8946ECS/R Folha de dados(PDF) 72 Page - Wolfson Microelectronics plc