SST58LM032 datasheet(29/40 Pages) SST

29 / 40 page

Advance Information

ATA-Disk Module

SST58SM008 / 016 / 024 / 032 / 048 / 064 / 096 / 128 / 192

SST58LM008 / 016 / 024 / 032 / 048 / 064 / 096 / 128 / 192

S71193-01-000

9/01

519

3.2.1.15 Set Features - EFH

This command is used by the host to establish or select certain features. Table 3-5 defines all features that are

supported.

Features 01H and 81H are used to enable and clear 8-bit data transfer mode. If the 01H feature

command is issued all data transfers will occur on the low order D7-D0 data bus and the IOCS16#

signal will not be asserted for data register accesses.

Features 55H and BBH are the default features for the ADM; thus, the host does not have to issue this

command with these features unless it is necessary for compatibility reasons.

Features 66H and CCH can be used to enable and disable whether the Power On Reset (POR)

Defaults will be set when a software Reset occurs.

Bit ->

Command (7)

EFH

C/D/H (6)

XDrive

Cyl High (5)

Cyl Low (4)

Sec Num (3)

Sec Cnt (2)

Config

Feature (1)

Feature

TABLE

3-5: FEATURES SUPPORTED

Feature

Operation

01H

Enable 8-bit data transfers.

55H

Disable Read Look Ahead.

66H

Disable Power on Reset (POR) establishment of defaults at software Reset.

69H

NOP - Accepted for backward compatibility.

81H

Disable 8-bit data transfer.

96H

NOP - Accepted for backward compatibility.

97H

NOP - Accepted for backward compatibility.

9AH

NOP - accepted for compatibility.

BBH

4 Bytes of data apply on Read/Write Long commands.

CCH

Enable Power on Reset (POR) establishment of defaults at software Reset.

T3-5.1 519

SST58LM032 Folha de dados(PDF) 29 Page - Silicon Storage Technology, Inc

SST58LM032 Folha de dados(HTML) 29 Page - Silicon Storage Technology, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Folha de dados Download

Ligação URL