DLD datasheet(57/76 Pages) ITT

57 / 76 page

Dimensions are shown in mm (inch)

Dimensions subject to change

ZIF Connectors

Tools and Assembly

Assembly Instructions for Crimp Contacts

Contact Insertion:

All crimp contacts are inserted by hand. No tooling

is required for either the plug or receptacle.

Caution:

Caution: Do not force contacts into contact

cavities.

contact

encounters

excessive

resistance during installation remove and re-insert

using a slight up and down motion. This will assure

positive cavity alignment.

Do not install contact if

plug is in the

closed or actuated position.

Plug:

Step 1. Prior to inserting contacts, turn the shaft

counter-clockwise to its maximum

open position.

Step 2. With the retention lance positioned

away

from the shaft, insert contacts from the rear of the

plug.

Receptacle:

Step 1. With the retention lance positioned

toward

the shaft hole, insert contacts from the rear of the

receptacle.

Contact Removal for Crimp Contacts

Tool: CET-DL10

Release retention lance by inserting tip of

extraction tool into cavity until it bottoms on

insulator shoulder. Gently pull wire in direction of

arrow, see illustration, to remove contact from

insulator.

CAM

RETENTION

LANCE

(BOTTOM)

RETENTION

LANCE

(TOP)

RECEPTACLE

CONNECTOR

PLUG

CONNECTOR

SCREW

POLARIZING

POST

RETENTION

LANCE

(BOTTOM)

RETENTION

LANCE

(TOP)

CONTACT

RETENTION

LANCE

DLD Folha de dados(PDF) 57 Page - ITT Industries

DLD Folha de dados(HTML) 57 Page - ITT Industries

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76

Folha de dados Download

Ligação URL