©2011 Silicon Storage Technology, Inc.

S71296-05-000

02/11

6

8 Mbit SPI Serial Flash

SST25VF080B

Data Sheet

A Microchip Technology Company

Hold Operation

The HOLD# pin is used to pause a serial sequence underway with the SPI flash memory without reset-

ting the clocking sequence. To activate the HOLD# mode, CE# must be in active low state. The HOLD#

mode begins when the SCK active low state coincides with the falling edge of the HOLD# signal. The

HOLD mode ends when the HOLD# signal’s rising edge coincides with the SCK active low state.

If the falling edge of the HOLD# signal does not coincide with the SCK active low state, then the device

enters Hold mode when the SCK next reaches the active low state. Similarly, if the rising edge of the

HOLD# signal does not coincide with the SCK active low state, then the device exits in Hold mode

when the SCK next reaches the active low state. See Figure 4 for Hold Condition waveform.

If CE# is driven active high during a Hold condition, it resets the internal logic of the device. As long as

HOLD# signal is low, the memory remains in the Hold condition. To resume communication with the device,

HOLD# must be driven active high, and CE# must be driven active low. See Figure 24 for Hold timing.

Figure 4: Hold Condition Waveform

Write Protection

SST25VF080B provides software Write protection. The Write Protect pin (WP#) enables or disables

the lock-down function of the status register. The Block-Protection bits (BP3, BP2, BP1, BP0, and BPL)

in the status register provide Write protection to the memory array and the status register. See Table 4

for the Block-Protection description.

Write Protect Pin (WP#)

The Write Protect (WP#) pin enables the lock-down function of the BPL bit (bit 7) in the status register.

When WP# is driven low, the execution of the Write-Status-Register (WRSR) instruction is determined by

the value of the BPL bit (see Table 2). When WP# is high, the lock-down function of the BPL bit is disabled.

Table 2: Conditions to execute Write-Status-Register (WRSR) Instruction

WP#

BPL

Execute WRSR Instruction

L

1

Not Allowed

L

0

Allowed

H

X

Allowed

T2.0 1296

Active

Hold

Active

Hold

Active

1296 HoldCond.0

SCK

HOLD#