Copyright © 2008 Future Technology Devices International Limited

7

Document Reference No.: FT_000065

TTL-232R-PCB TTL TO USB SERIAL CONVERTER PCB Datasheet Version 1.01

Clearance No.: FTDI# 54

E-Mail (Support): cn.support@ftdichip.com

E-Mail (General Enquiries): cn.admin1@ftdichip.com

Web Site URL: http://www.ftdichip.com

Distributor and Sales Representatives

Please visit the Sales Network page of the FTDI Web site for the contact details of our distributor(s) and

sales representative(s) in your country.

Appendix A - PCB EEPROM Configuration. A user area of the internal EEPROM is available to system

designers to allow storing additional data. The internal EEPROM descriptors can be programmed in circuit,

over USB without any additional voltage requirement. It can be programmed using the FTDI utility

software called FT_PROG, which can be downloaded from FTDI Utilities on the FTDI website

(www.ftdichip.com).

Lower Operating and Suspend Current. The FT232R has a low 15mA operating supply current and a

very low USB suspend current of approximately 70μA.

Low USB Bandwidth Consumption. The USB interface of the FT232R, and therefore the TTL-232R_PCB

has been designed to use as little as possible of the total USB bandwidth available from the USB host

controller.

High Output Drive Option. The UART interface I/O pins on the TTL-232R_PCB (RXD, TXD, RTS#, and

CTS#) can be configured to use the FT232R’s high output drive option. This option allows the FT232R

I/O pins to drive up to three times the standard signal drive level. This allows multiple devices to be

driven, or devices that require a greater signal drive strength to be interfaced on the PCB. This option is

enabled in the internal EEPROM.

UART Pin Signal Inversion. The sense of each of the UART signals can be individually inverted by

configuring options in the internal EEPROM. For example CTS# (active low) can be changed to CTS

(active high), or TXD can be changed to TXD#.

FTDIChip-ID™. The FT232R includes the new FTDIChip-ID™ security dongle feature. This FTDIChip-ID™

feature allows a unique number to be burnt into each FT_232RQ during manufacture. This number cannot

be reprogrammed. This number is only readable over USB can be used to form the basis of a security

dongle which can be used to protect any customer application software being copied. This allows the

possibility of using the TTL-232R_PCB as a dongle for software licensing. Further to this, a renewable

license scheme can be implemented based on the FTDIChip-ID™ number when encrypted with other

information. This encrypted number can be stored in the user area of the FT232R internal EEPROM, and

can be decrypted, then compared with the protected FTDIChip-ID™ to verify that a license is valid. Web

based applications can be used to maintain product licensing this way. An application note, AN232R-02,

available from FTDI website (www.ftdichip.com) describes this feature.

Extended Operating Temperature Range - The TTL-232R_PCB is capable of operating over an

extended temperature range of -40º to +85ºC thus allowing it to be used in automotive or industrial

applications.