SA9101 datasheet(28/40 Pages) SAMES

28 / 40 page

SA9101

sames

28/40

Status Register

ADR 0

PCM/SA9101 Alarm status

Bit

Description

Name

SR0B0

Slip Direction Indication

0 =

negative slip, receive route clock frequency higher

than

internal system clock.

1 =

positive slip, receive route clock frequency below

internal

system clock.

SR0B1

CRC4 Multiframe alarm

Set after reset, multiframe synchronization lost or via uP-

Interface with command “Force Re-synchronisation”.

Will be reset after receiving 2 multi-frames without errors.

SR0B2

Receive Channel Parity Error

Set after device detects a channel parity error.

Cleared by setting control register ADR 0, bit 2 (Clear Channel

Parity Alarm Latch).

SR0B3

Receive Slip Indication

This bit changes state when a frame is dropped (RCLK > SCLK)

or repeated (SCLK > RCLK) .

A successful alarm-simulation causes one change.

SR0B4

Receive Remote Alarm

Bit 3 of received service word.

SR0B5

Loss Of Synchronisation

Will be set if incorrect frame alignment signal or service word

was detected 3 times in sequence.

Is automatically reset after sequence FAS-SW-FAS is received.

Loss of synchronisation is also indicated if “No Signal” occurs

because of no Route Clock.

SR0B6

Alarm Indication Signal (AIS)

If less than two “0’s” are detected in an incoming bitstream of

512 bits, this bit is set to “1”.

SR0B7

No Signal

If less than four “1’s” are in a stream of 512 bits or no complete

receive clock pulse occurs within 4 periods of the system clock,

this bit is set to “1”.

SA9101 Folha de dados(PDF) 28 Page - Sames

SA9101 Folha de dados(HTML) 28 Page - Sames

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Folha de dados Download

Ligação URL