PD064VT5

The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be

distributed, reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co.,

Ltd.

Page:23

Revision History

Rev.

Issued

Date

Revised

Contents

1.0

Jan. 28 , 2004

New

1.1

Nov.01,2004

Modify

Page7: 7-2)Recommended Operation Condition for backlight

Kick off voltage(25 ) from 790 to 970

Add: Kick-off voltage(0 )

Page22: Packing drawing

1.2

Jan.11,2005

Remove

Page 20: Indication of Lot Number Label

Add:

Page 20: Reliability

(Note the protective film must be remove before temperature test)

1.3

Jan.02, 2006

Page4 Mechanical Drawing of TFT-LCD Module

1.Add screw torsion SPEC.(1.5kgf-cm , Max)

2.Modify switch1 Pin NO. from 9 pins to 8 Pins

3.Modify switch2 Pin NO. from 3 pins to 2 Pins

Page14 7-8)Control Board Dip switch Format

SW1:

SW1-2 (Rework): form Default(ON) modify to Default(OFF)

SW1-3 (Rework) :form Default(OFF) modify to Default(ON)

SW1-4 (Rework): form Default(OFF) modify to Default(ON)

1.4

Apr.28 2006,

Page8: 7-4)Input/ Output signal timing chart

Hsync (Back-porch) Typ. From 48tc modify to 46tc

Hsync(Front-porch) Typ. From 16tc modify to 18tc

Hsync(Hpw+Hbp) Typ. From 144 tc modify to 142 tc

Page14 7-8)Control Board Dip switch Format

SW1:

SW1-2 (Rework): form Default(OFF) modify to Default(ON)

SW1-3 (Rework) :form Default(ON) modify to Default(OFF)

SW1-4 (Rework): form Default(ON) modify to Default(OFF)