TCM4400EPET datasheet(49/64 Pages) TI

49 / 64 page

TCM4400E

GSM/DCS BASEBAND AND VOICE A/D

AND D/A RF INTERFACE CIRCUIT

SLWS082A – JULY 1999 – REVISED MARCH 2000

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

PRINCIPLES OF OPERATION

power down register No. 1

The values in each bit position of power down register No. 1 have the meaning outlined in Table 14.

Table 14. PWDNRG1 Register

PWDNRG1: REGISTER FOR POWERING DOWN

ADDRESS: 7

R/W

SELVMID

BALOOP

VMIDW

VMIDPD

BBULW

BBULPD

BBDLW

BBDLPD

EXTCAL

BBRST

1/0

R/W

<–ACCESS TYPE

<–VALUE AT RESET

BBRST:

This is the digital reset of the baseband codec (active at 1); the uplink burst buffer is loaded with

all 1s and the memory and registers of the downlink digital filter is cleared to 0. This is not a

toggle bit as it has to be set to 0 to remove the reset condition.

EXTCAL:

Downlink autocalibration mode (at 0: autocalibration; at 1: external calibration)

BBULW:

If cleared to 0, the baseband uplink path is powered down under the control of the GSM transmit

window (BULON terminal). If this bit is set to 1, the power down is only controlled by bit

BBULPD.

BBULPD:

This bit is functionally associated with bit BBULW. When this bit is set to 1, the baseband uplink

path is in power-down mode.

BBDLW:

If cleared to 0, the baseband downlink path is powered down under the control of GSM receive

window (BDLON terminal). If this bit is set to 1, the power down is only controlled by bit

BBDLPD.

BBDLPD:

This bit is functionally associated with bit BBDLW. When this bit is set to 1, the baseband

downlink path is in power-down mode.

VMIDW:

If cleared to 0, the VMID output driver is powered down under the control of GSM transmit

window (BULON terminal). If this bit is set to 1, the power down is only controlled by bit

VMIDPD.

VMIDPD:

This bit is functionally associated and paired with bit VMIDW. When VMIDW bit is set to 1, the

VMID output driver is active. When VMIDPD bit is set to 1, the VMID output driver is in

power-down mode.

BALOOP:

When set to 1, the internal analog loop of I and Q uplink terminals are connected to I and Q

downlink terminals.

SELVMID: When cleared to 0, this sets the common-mode voltage of the baseband uplink and VMID at

VDD/2; when set to 1, these voltages are set to 1.35 V.

TCM4400EPET Folha de dados(PDF) 49 Page - Texas Instruments

TCM4400EPET Folha de dados(HTML) 49 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Folha de dados Download

Ligação URL