Os motores de busca de Datasheet de Componentes eletrônicos
  Portuguese  ▼
ALLDATASHEETPT.COM

X  

LTC2481 Folha de dados(PDF) 21 Page - Linear Technology

Nome de Peças LTC2481
Descrição Electrónicos  16-Bit ?誇 ADC with Easy Drive Input Current Cancellation and I2C Interface
PDF  40 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Fabricante Electrônico  LINER [Linear Technology]
Página de início  http://www.linear.com
Logo LINER - Linear Technology

LTC2481 Folha de dados(HTML) 21 Page - Linear Technology

Back Button LTC2481 Datasheet HTML 17Page - Linear Technology LTC2481 Datasheet HTML 18Page - Linear Technology LTC2481 Datasheet HTML 19Page - Linear Technology LTC2481 Datasheet HTML 20Page - Linear Technology LTC2481 Datasheet HTML 21Page - Linear Technology LTC2481 Datasheet HTML 22Page - Linear Technology LTC2481 Datasheet HTML 23Page - Linear Technology LTC2481 Datasheet HTML 24Page - Linear Technology LTC2481 Datasheet HTML 25Page - Linear Technology Next Button
Zoom Inzoom in Zoom Outzoom out
 21 / 40 page
background image
21
LTC2481
2481f
APPLICATIO S I FOR ATIO
first conversion result following POR is accurate within the
specifications of the device if the power supply voltage is
restored within the operating range (2.7V to 5.5V) before
the end of the POR time interval.
On-Chip Temperature Sensor
The LTC2481 contains an on-chip PTAT (proportional to
absolute temperature) signal that can be used as a tempera-
ture sensor. The internal PTAT has a typical value of 420mV
at 27
°C and is proportional to the absolute temperature
value with a temperature coefficient of 420/(27 + 273) =
1.40mV/
°C (SLOPE), as shown in Figure 11. The internal
PTAT signal is used in a single-ended mode referenced to
device ground internally. The GAIN is automatically set to
one (independent of the values of GS0, GS1, GS2) in order
to preserve the PTAT property at the ADC output code and
avoid an out of range error. The 1x speed mode with auto-
matic offset calibration is automatically selected for the in-
ternal PTAT signal measurement as well.
When using the internal temperature sensor, if the output
code is normalized to RSDA = VPTAT/VREF, the temperature
is calculated using the following formula:
If the same VREF source is used during calibration and
temperature measurement, the actual value of the VREF is
not needed to measure the temperature as shown in the
calculation below:
SLOPE
RV
T
SDA
REF
=
+
0
0
273
•
T
RV
SLOPE
R
R
T
C
SDA
REF
SDA
SDA
=
=+
()
•
–
•–
273
0
0
273
273
Figure 11. Internal PTAT Signal vs Temperature
TEMPERATURE (
°C)
–60
500
600
120
2481 F12
400
200
30
090
–30
60
300
VCC = 5V
IM = 1
SLOPE = 1.40mV/
°C
where SLOPE is nominally 1.4mV/
°C.
Since the PTAT signal can have an initial value variation
which results in errors in SLOPE, to achieve absolute
temperature measurements, a one-time calibration is
needed to adjust the SLOPE value. The converter output of
the PTAT signal, R0SDA, is measured at a known tempera-
ture T0 (in
°C) and the SLOPE is calculated as:
This calibrated SLOPE can be used to calculate the
temperature.
Reference Voltage Range
The LTC2481 external reference voltage range is 0.1V to
VCC. The converter output noise is determined by the
thermal noise of the front-end circuits, and as such, its
value in nanovolts is nearly constant with reference volt-
age. Since the transition noise (600nV) is much less than
the quantization noise (VREF/217), a decrease in the refer-
ence voltage will increase the converter resolution. A
reduced reference voltage will also improve the converter
performance when operated with an external conversion
clock (external FO signal) at substantially higher output
data rates (see the Output Data Rate section). VREF must
be
≥1.1V to use the internal temperature sensor.
The reference input is differential. The differential refer-
ence input range (VREF = REF+ – REF–) is 100mV to VCC
and the common mode reference input range is 0V to VCC.
T
RV
SLOPE
T
RV
SLOPE
K
SDA
REF
C
SDA
REF
=
=°
•
•
–
in Kelvin
and
in C
273



Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40


Folha de dados Download

Go To PDF Page


Ligação URL



ALLDATASHEET é útil para você?  [ DONATE ] 

Sobre Alldatasheet   |   Publicidade   |   Contato conosco   |   Privacy Policy   |   Link para a ficha técnica    |   roca de Link   |   Lista de Fabricantes
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com