STDS75 datasheet(13/37 Pages) STMICROELECTRONICS

Nome de Peças	STDS75

Descrição Electrónicos	Digital temperature sensor and thermal watchdog

PDF	37 Pages

Scroll/Zoom	100%

Fabricante Electrônico	STMICROELECTRONICS [STMicroelectronics]

Página de início	http://www.st.com

Logo

13 / 37 page

STDS75

Operation

13/37

2.4

Interrupt mode

In Interrupt mode, the OS/INT output first becomes active when the measured temperature

exceeds the TOS value a consecutive number of times equal to the FT value in the

configuration register. Once activated, the OS/INT can only be cleared by either putting the

STDS75 into shutdown mode or by reading from any register (temperature, configuration,

TOS, or THYS) on the device. Once the OS/INT has been deactivated, it will only be

reactivated when the measured temperature falls below the THYS value a consecutive

number of times equal to the FT value. Figure 5 illustrates typical OS output temperature

response for STDS75 configured to have a fault tolerance of 2. The interrupt/clear process

is cyclical between TOS and THYS.

Figure 5.

OS output temperature response diagram

This assumes that a READ has occurred.

Note:

The STDS75 is configured to have a fault tolerance of 2 in this example.

(1)

Conversions

TOS

Temperature

THYS

Inactive

Active

Inactive

Active

OS Output - Comparator mode

OS Output - Interrupt mode

(1)

AI12224b

STDS75 Folha de dados(PDF) 13 Page - STMicroelectronics