AT89C51ID2-RDTIM datasheet(117/159 Pages) ATMEL

117 / 159 page

117

AT89C51ID2

4289A–8051–09/03

Flash Memory

The Flash memory increases EPROM and ROM functionality with in-circuit electrical

erasure and programming. It contains 64K bytes of program memory organized respec-

tively in 512 pages of 128 bytes. This memory is both parallel and serial In-System

Programmable (ISP). ISP allows devices to alter their own program memory in the

actual end product under software control. A default serial loader (bootloader) program

allows ISP of the Flash.

The programming does not require external dedicated programming voltage. The nec-

essary high programming voltage is generated on-chip using the standard V

CC pins of

the microcontroller.

Features

•

Flash internal program memory.

•

Boot vector allows user provided Flash loader code to reside anywhere in the Flash

memory space. This configuration provides flexibility to the user.

•

Default loader in Boot ROM allows programming via the serial port without the need

of a user provided loader.

•

Up to 64K byte external program memory if the internal program memory is disabled

(EA = 0).

•

Programming and erase voltage with standard power supply.

•

Read/Programming/Erase:

•

Byte-wise read without wait state

•

Byte or page erase and programming (10 ms)

•

Typical programming time (64K bytes) is 22s with on chip serial bootloader

•

Parallel programming with 87C51 compatible hardware interface to programmer

•

Programmable security for the code in the Flash

•

100k write cycles

•

10 years data retention

Flash Programming and

Erasure

The 64K bytes Flash is programmed by bytes or by pages of 128 bytes. It is not neces-

sary to erase a byte or a page before programming. The programming of a byte or a

page includes a self erase before programming.

There are three methods of programming the Flash memory:

•

First, the on-chip ISP bootloader may be invoked which will use low level routines to

program the pages. The interface used for serial downloading of Flash is the UART.

•

Second, the Flash may be programmed or erased in the end-user application by

calling low-level routines through a common entry point in the Boot ROM.

•

Third, the Flash may be programmed using the parallel method by using a

conventional EPROM programmer. The parallel programming method used by

these devices is similar to that used by EPROM 87C51 but it is not identical and the

commercially available programmers need to have support for the AT89C51ID2.

The bootloader and the Application Programming Interface (API) routines are

located in the BOOT ROM.

AT89C51ID2-RDTIM Folha de dados(PDF) 117 Page - ATMEL Corporation

AT89C51ID2-RDTIM Folha de dados(HTML) 117 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Folha de dados Download

Ligação URL