ST95020 datasheet(10/18 Pages) STMICROELECTRONICS

Nome de Peças	ST95020

Descrição Electrónicos	4K/2K/1K Serial SPI EEPROM with Positive Clock Strobe

PDF	18 Pages

Scroll/Zoom	100%

Fabricante Electrônico	STMICROELECTRONICS [STMicroelectronics]

Página de início	http://www.st.com

Logo

10 / 18 page

DATA PROTECTION AND PROTOCOL SAFETY

– All inputs are protected against noise, see Table

– Non valid S and HOLD transitions are not taken

into account.

– S must come high at the proper clock count in

order to start a non-volatile write cycle (in the

memory array or in the status register), that is

the Chip Select S mustrise during the clock pulse

following the introduction of a multiple of 8 bits.

– Access to the memory array during non-volatile

programming cycle is ignored; however, the pro-

gramming cycle continues.

– After any of the operations WREN, WRDI, RDSR

is completed, the chip enters a wait state and

waits for a deselect.

– The write enable latch is reset upon power-up.

– The write enable latch is reset when W is brought

low.

INITIAL DELIVERY STATE

The device is delivered with the memory array in a

fully erased state (all data set at all ”1’s” or FFh).

The block protect bits are initialized to 00.

AI01446

MASTER

ST95xxx

CS3

CS2

CS1

Figure 12. EEPROM and SPI Bus

10/18

ST95040, ST95020, ST95010

ST95020 Folha de dados(PDF) 10 Page - STMicroelectronics