B2425 datasheet(4/36 Pages) HAKKO

4 / 36 page

Loosen the adjusting screws to change the angle

of the handpiece receptacle as you like, then tighten

the screws.

4. INITIAL SETUP

A. Handpiece holder

First, remove any excess solder from the nozzle by

thrusting the nozzle into the cleaning wire. (Do not wipe

the nozzle against the wire. This may cause molten

solder to spatter.)

●

Operation

Following the instructions given in the illustration

on the right, assemble the handpiece holder.

1. Insert the holder assembly securely into the handpiece

holder base.

2. When the cleaning wire becomes dirty or loaded with

solder, turn the wire until a clean surface is presented.

3. When changing the cleaning wire, lift the top vertically

to prevent solder debris from falling out.

CAUTION

Do not set up the angle of the handpiece receptacle too high, or

the temperature of the handpiece will become very hot.

B. HAKKO FR-4001

●

Replacing the filter

Replace the filter as shown following steps

A to C. During operation, the filter pipe is

very hot. Wait until the filter pipe is cool

before replacing the filter or cleaning.

We recommend keeping a second filter

pipe containing new filters handy, and

replacing the installed filter pipe with this

secondary filter pipe.

B. Pull

A. Down

C. Replace the entire filter pipe with

a secondary filter pipe.

B2425 Folha de dados(PDF) 4 Page - HAKKO Corporation