Copyright © 2010 Future Technology Devices International Limited

2

Document Reference No.: FT_000118

USB-COM232-PLUS1 Datasheet

Version 1.2

Clearance No.: FTDI# 76

1.2 LED Description

The USB-COM232-Plus1 uses three LEDs to indicate a valid link as well as data traffic according to the

following table:

LED Color

Function

Description

Yellow

Enumerated

ON when USB-COM-Plus is configured and ready

Green

TxD Activity

Flashes when data is transmitted from the

USB-COM232-Plus1 to the

attached RS232 device

Red

RxD Activity

Flashes when data is transmitted from the attached RS232 device to the

USB-COM232-Plus1

Table 1.1 – LED Description

1.3 Block Diagram

FTDI FT232R

USB Serial Bridge

RS232

Level Shifter

USB B

Client

Connector

DE-9P

Connector

Figure 1.2 USB-COM232-Plus1 Block Diagram

1.3.1 Block description

USB B Client Connector

This connector provides the interface for connection to a USB Host or Hub port. The maximum cable

length is 5 meters, according to the USB 2.0 specification.

FTDI FT232R

The FTDI FT232R provides the USB-to-Serial conversion. Operating system device drivers are required in

order to work with the FT232R to provide the Virtual COM Port serial functionality.

RS232 Level Shifter

The RS232 level shifter converts the signals provided by the FT232R into the voltage levels required by

RS232 devices.

DE-9P Connector (Male)

The DE-9P connector is configured in an industry standard (TIA/EIA-574) pin-out to provide connection to

RS232 peripherals through standard cables. See section 3.1.2