Introduction
The APCI-IB40 is a 32-bit PCI Local Bus I/O board which provides 40 digital I/O lines and three
timer/counters. Each I/O line can be configured as either an input or an output. The board also has
the facility to define the power-up/reset state of those lines to be used as outputs. The I/O
connector conforms to Arcoms standard signal conditioning system (SCS) and may be used to drive
a range of Signal Conditioning Boards (SCB), contact Arcom for more details.
Features
40 Digital I/O lines.
Open collector outputs can sink 24mA @ 0.45V, Sources from 4K7 Ohm at +5V.
Bit programmable for input or output.
8254 Compatible Timer/Counter (Three 16-bit Counters).
Board Access LED (Red).
User programmable LED (Green).
32-Bit PCI 2.1 Compliant Interface.
EEPROM for PCI Interface configuration.
50 Way D-Type I/O Connector (Configured for Arcom Signal Conditioning System).
Operating Temperature range 0 to +70 C.
Power Consumption 220mA @ +5V.
MTBF 370,030 hours (using generic figures from MIL-HDBK-217F at ground benign).
Getting Started
Power down your PC system.
Install the board in a spare PCI Slot (See Installation for CE compliance).
Power up system with MSDOS.
Run APCI.EXE (supplied on the utility disk), this will search for the board and check I/O access. If
this fails, check board is correctly located.
Warning
This board contains CCM
MO
OSS devices which may be damaged by static electricity. Please ensure anti-
static precautions are taken at all times when handling this board. If for any reason this board is
returned to Arcom Control Systems, please ensure it is adequately packed to prevent damage during
shipment.
APCI-IB40
2192-09099-000-000
J591 APCI-IB40
Page 1
Portuguese ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
