7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

5. Connect the support beams to the long beams. First bend the flexible tabs

to 90 degrees to pass them through the slots in the long beams.

•

The tab initially lays flat against the long beam.

6. Next, bend the tab back through 180 degrees to grip the long beam.

•

Use a screwdriver or similar tool to bend the tabs.

7. Finally bend the tab again through 90 degrees the opposite way, to seat

tightly against the support beam.

8. Ensure there is no movement between the beams.