7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

12. Connect the hydraulic hose to the

ram cylinder, sealing the joint with

PTFE tape and tighten using two

open ended spanners.

13. The pressure gauge is sealed for

transit and it will be necessary to

make a small hole in the pressure

gauge safety bung with a short

pin or nail before use.

•

Do not use a long nail as you

may damage the internal

components of the gauge.

14. Bolt the pressure gauge into

position on the hydraulic ram.

•

We recommend sealing the

thread with PTFE tape. Take

care not to let any oil escape

while connecting the hose.

15. Top up the hydraulic oil to the

lower level of the filler plug.