March 08, 2024

WLF12 Flexible LED Strip Light Instruction Manual 

© Banner Engineering Corp. All rights reserved.

 

 

6

Chapter Contents

 

Cutting Instructions

Chapter 4

Prepare the flexible LED strip light and remove power.

1.

Cut along one of the cutting lines located between each section of six LEDs that are spaced every 50 mm.

2.

Peel back part of the tape on the back, and trim it off.

3.

Cover the cut end of the light with silicone glue.

4.

Take the extra supplied silicone end cap, and put it on the end of the light. Press out excess glue.

5.

Clean the light of the excess glue.

6.

Allow twenty-four hours for the glue to dry.

7.