301201 datasheet(2/6 Pages) TEC

2 / 6 page

408-1535

2 of 6

Rev S

Figure 2

2. To open the crimping jaws, close the tool handles

until the CERTI-CRIMP hand tool ratchet releases.

Note that the tool handles cannot be opened until

they are FULLY closed.

3. Push the locator up and, from the FRONT side of

the tool, insert the terminal or splice wire barrel

sleeve into the crimping jaws making sure that the

edge of the wire barrel sleeve rests against the

locator. See Figure 3 and Figure 4.

4. Close tool handles just enough to hold the

terminal or splice within the crimping jaws.

Figure 3

Figure 4

Closing the tool handles too tightly will deform the

terminal or splice.

5. Insert wire conductor through the insulation barrel

sleeve and into the wire barrel sleeve until it is flush

with the outer edge of the wire barrel sleeve. See

Figure 3 and Figure 4.

TOOL

WIRE

SIZE

(AWG)

INSULATION

RANGE

STRIP

LENGTH

46673

22-16

2.67-3.56

[.105-.140]

5.16 - 5.94

[.203 - .234]

46673-1

1.68-3.43

[.066-.135]

46988

16-14

3.05-4.32

[.120-.170]

Edge of Wire Barrel Sleeve

Resting Against Locator

Terminal Tongue Through

Slot in Locator

Wire Barrel

Sleeve

InsulationBarrel

Sleeve

Push Locator Up So That

Terminal Tongue Slides

Through Slot in Locator

Insert Wire Conductor

Through Insulation Barrel

Sleeve and into Wire Barrel

Sleeve

Back Side of Tool

Terminal Crimp

Edge of Wire Barrel

Sleeve Resting Against

Locator

Open Section of Splice

in Slot in Locator

Insulation Barrel

Sleeve

Wire Barrel

Sleeve

Push Locator Up So That

Splice Slides Through

Slot in Locator

Insert Wire Conductor

Through Insulation Barrel

Sleeve and into Wire

Barrel Sleeve

Back Side of Tool

Splice Crimp (First Crimp)

NOTE

301201 Folha de dados(PDF) 2 Page - TE Connectivity Ltd

301201 Folha de dados(HTML) 2 Page - TE Connectivity Ltd

Html Pages

1 2 3 4 5 6

Folha de dados Download

Ligação URL