L6563ATR datasheet(22/39 Pages) STMICROELECTRONICS

22 / 39 page

Application information

L6563 - L6563A

22/39

Figure 38. THD optimization: standard TM PFC controller (left side) and L6563/A

(right side)

Essentially, the circuit artificially increases the ON-time of the power switch with a positive

offset added to the output of the multiplier in the proximity of the line voltage zero-crossings.

This offset is reduced as the instantaneous line voltage increases, so that it becomes

negligible as the line voltage moves toward the top of the sinusoid. Furthermore the offset is

modulated by the voltage on the VFF pin (see Section 6.3 on page 18 section) so as to have

little offset at low line, where energy transfer at zero crossings is typically quite good, and a

larger offset at high line where the energy transfer gets worse.

The effect of the circuit is shown in Figure 38, where the key waveforms of a standard TM

PFC controller are compared to those of this chip.

To take maximum benefit from the THD optimizer circuit, the high-frequency filter capacitor

after the bridge rectifier should be minimized, compatibly with EMI filtering needs. A large

capacitance, in fact, introduces a conduction dead-angle of the AC input current in itself -

even with an ideal energy transfer by the PFC pre-regulator - thus reducing the effectiveness

of the optimizer circuit.

Imains

Vdrain

Imains

Vdrain

Input current

MOSFET's drain voltage

Rectified mains voltage

Input current

L6563ATR Folha de dados(PDF) 22 Page - STMicroelectronics