AD-ICD

3 Connecting to the application board

7/15

3

Connecting to the application board

This chapter describes the physical connection of the ICD adapter to your in-circuit

debugging tool and to your application board.

Note:

The DB715 flexible and associated on-application connectors for the DFN8 package are

delivered with the ST7MDT10-8/DVP connection kit (see Delivery checklist).

The following sections show connection illustrations for each supported package type:

●

Connection for DIP8 microcontroller package on page 8

●

Connection for SO8 microcontroller package on page 9

●

Connection for DFN8 microcontroller package on page 10

Figure 6.

Connectors on the ICD Adapter

The ICD Adapter (MB509) connects to

your in-circuit debugging tool via the

10-pin ICC connector on the top of the

adapter. It connects to the connector

installed on you application board via

an 8-pin connector on the bottom of

the adapter (see

Figure 6).

To use the ICD Adapter you will have

to solder the appropriate package

specific connector to your application

board in place of your target

ST7LiteUS microcontroller.

Table 2

shows the available connectors

Table 2.

Target MCU packages and their application connectors

Package

ICD Adapter

Application board connector(s)

DIP8

MB509

DB646

SO8

MB509

SO8, 8-pin connector

DFN8

MB509

DB715 flexible adapter

10-pin ICC connector

8-pin connector

Top

Bottom