SL2S3003FUD datasheet(69/82 Pages) NXP

69 / 82 page

NXP Semiconductors

SL2S3003/SL2S3003TT

ICODE 3 (TagTamper)

8.6 Error handling

8.6.1 Transmission errors

In compliance with ISO/IEC 15693[1], the label IC does not respond if a transmission error is detected.

Examples of transmission errors are CRC, bit coding, bit count, or wrong framing. The device waits for the next

correct received command.

8.6.2 Commands not supported or options

If the received command or option is not supported, the behavior of the label IC depends on the addressing

mechanism.

8.6.2.1 Non-addressed Mode

The label IC remains silent.

8.6.2.2 Addressed or Selected Mode

In addressed mode or in selected mode, the label IC responds with the error code "0Fh" (error with no

information given or error code is not supported).

If the Inventory flag or the Protocol Extension flag is set, the label IC does not respond if the command or option

is not supported.

8.6.3 Parameter out of range

8.6.3.1 Read commands

If the sum of the first block number and the number of blocks exceeds the total number of available user blocks,

the number of transmitted blocks is less than the requested number of blocks. The last returned block is the

highest available user block, followed by the 16-bit CRC and the EOF.

8.6.3.2 Write and lock commands

If the address of a block to be written does not exist, or if a block to be written is locked, the behavior of the

label IC depends on the addressing mechanism.

Non-addressed Mode

• The label IC remains silent and aborts the command without writing anything.

Addressed Mode or Selected Mode

• The addressed or selected label IC responds with the error code "0Fh" (error with no information given or

error code is not supported).

SL2S3003/SL2S3003TT

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 3.0 — 28 March 2024

69 / 82

SL2S3003FUD Folha de dados(PDF) 69 Page - NXP Semiconductors