SPL S1L90H_3

DATASHEET

DATASHEET

18 | Version 1.0 | 2023-01-23

Glossary

1)

Brightness: The brightness values are measured with a tolerance of ±11%.

2)

Wavelength: The wavelengths are measured with a tolerance of ±1 nm.

3)

Typical Values: Due to the special conditions of the manufacturing processes of semiconductor devic-

es, the typical data or calculated correlations of technical parameters can only reflect statistical figures.

These do not necessarily correspond to the actual parameters of each single product, which could dif-

fer from the typical data and calculated correlations or the typical characteristic line. If requested, e.g.

because of technical improvements, these typ. data will be changed without any further notice.

4)

Testing temperature: TA = 25°C (unless otherwise specified)

5)

Tolerance of Measure: Unless otherwise noted in drawing, tolerances are specified with ±0.1 and

dimensions are specified in mm.

6)

Tape and Reel: All dimensions and tolerances are specified acc. IEC 60286-3 and specified in mm.