Hardness Tester PCE-HT 224E with Digital Display

Hardness Tester PCE-HT 224E with Digital Display

Mechanical concrete hardness tester with OLED / Measuring range 10 ... 60 N/mm² (1500 ... 8500 PSI or lbs/in²) / Data storage analysis software

/ Built-in battery for mobile use / Test load 2.207 J / For measuring the quality of concrete surfaces

The Hardness Tester is a measuring tool for testing the strength of concrete. The Hardness Tester measures strength according to the Schmidt

principle. According to this measurement method, the quality of concrete can be measured with the Hardness Tester. Thus, the Hardness Tester

finds its essential application in the construction and in the construction sector. The Hardess Tester is also suitable for measuring the hardness

of rolled paper.  The built-in mechanism on the hardness tester always ensures the same impact energy of 2.207 Nm. 

In addition to testing concrete, the Hardness Tester can also store measured data. The stored measurement data can be transferred from the

Hardness Tester to a PC after a measurement run. For this, the mini-USB interface is available on the Hardness Tester. The evaluation of the

measurements from the hardness tester is carried out with the supplied PC software. 

The Hardness Tester displays measurements Rebound Value and can display force in PSI, MPa, kgF/cm², or N/mm². The Hardness Tester can be

setup to measure at test angles of downward(-90°), downward(-45°), horizontal (0°), upward(45°), or upward(90°). 

OLED for reading the measured values

USB interface for connection to a PC

Measuring range 10 ... 60 N/mm², 1500 ... 8500 PSI or lbs/in² 

Measurement of the hardness of concrete

Data storage for later analysis

Rechargeable battery for mobile use