L6701TR datasheet(6/44 Pages) STMICROELECTRONICS

6 / 44 page

2 Pins description and connection diagrams

L6701

6/44

BOOT2

Channel 2 HS driver supply.

Connect through a capacitor (100nF typ.) to PHASE2 and provide necessary

Bootstrap diode.

A small series resistor upstream the boot diode helps in reducing Boot capacitor

overcharge.

UGATE2

Channel 2 HS driver output.

A small series resistors helps in reducing device-dissipated power.

PHASE2

Channel 2 HS driver return path.

It must be connected to the HS2 MOSFET source and provides return path for

the HS driver of channel 2.

BOOT3

Channel 3 HS driver supply.

Connect through a capacitor (100nF typ.) to PHASE3 and provide necessary

Bootstrap diode.

A small series resistor upstream the boot diode helps in reducing Boot capacitor

overcharge.

UGATE3

Channel 3 HS driver output.

A small series resistors helps in reducing device-dissipated power.

PHASE3

Channel 3 HS driver return path.

It must be connected to the HS3 MOSFET source and provides return path for

the HS driver of channel 3.

SSEND /

PGOOD

SSEND - Intel VR10 Mode. Soft Start END Signal.

Open Drain Output set free after SS has finished and pulled low when triggering

any protection. Pull up to 5V (typ) or lower, if not used it can be left floating.

PGOOD - Intel VR9 & AMD Hammer Mode.

Open Drain Output set free after SS has finished and pulled low when VSEN is

lower than the relative threshold. Pull up to 5V (typ) or lower, if not used it can be

left floating.

DAC_SEL

DAC SELection pin.

It allows programming the DAC table for the regulation. Internally pulled-up to 5V.

Short to GND to program VR9 DAC, leave floating to program K8 DAC while

connect to GND through 82k

Ω to program VR10 DAC.

Information about the selected DAC is latched before the system start-up. See

Section 7.1 for connections to enable CPU auto-detection.

OSC / EN /

FAULT

OSC: It allows programming the switching frequency FSW of each channel.

Switching frequency can be increased according to the resistor connected from

the pin vs. SGND with a gain of 4kHz/µA (see Section 14). Leaving the pin

floating it programs a switching frequency of 100kHz per phase (300kHz on the

load).

EN: Forced low, the device stops operations with all MOSFETs OFF: all the

protections are disabled except for Preliminary Over Voltage. When set low it

resets the device from any latching condition.

FAULT: The pin is forced high (5V) to signal an OVP / UVP FAULT: to recover

from this condition, cycle VCC or the OSC pin. See Section 13 for details.

Table 1.

Pins description (continued)

Pin n

Name

Function

L6701TR Folha de dados(PDF) 6 Page - STMicroelectronics

L6701TR Folha de dados(HTML) 6 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Folha de dados Download

Ligação URL