13 / 16

Specifications are subject to changes without notice.

All specifications are typical at 25

C unless otherwise stated.

760W Programmable Driver with INV Digital Dimming

SSM-760SxxxMGS

Rev.A

www.inventronics-co.com

Tel: 86-571-56565800

Fax: 86-571-86601139

sales@inventronics-co.com

Implementation 6

: Negative logic

Notes:

1. Do NOT connect Dim− to the output V− or V+, otherwise the driver will not work properly.

2. When resistor negative logic dimming mode and Dim+ is open, the driver will dim to off and be standby.

 Time Dimming

Time dimming control includes 3 kinds of modes, they are Self Adapting-Midnight, Self Adapting-

Percentage and Traditional Timer.



Self Adapting-Midnight: Automatically adjusts the dimming curve based on the on-time of past two days

(if difference <15 minutes), assuming that the center point of the dimming curve is midnight local time.



Self Adapting-Percentage: Automatically adjusts the on-time of each step by a constant percentage =

(actual on-time for the past 2 days if difference <15 min) / (programmed on-time from the dimming curve).



Traditional Timer: Follows the programmed timing curve after power on with no changes.

 Output Lumen Compensation

Output Lumen Compensation (OLC) may be used to maintain constant light output over the life of the LEDs

by driving them at a reduced current when new, then gradually increasing the drive current over time to

counteract LED lumen degradation.

 Minimum Dimming Level with 5% or 10% Selectable

The minimum dimming level can be set as 5% or 10% by Inventronics Multi Programmer,10% is default.