AFL2805SWSLASHES datasheet(6/10 Pages) IRF

6 / 10 page

www.irf.com

AFL270XXD Series

Figure III. Preferred Connection for Parallel Operation

Synchronization of Multiple Converters

Parallel Operation-Current and Stress Sharing

Internally, these ports differ slightly in their function. In use,

a low on Enable 1 completely shuts down all circuits in the

converter, while a low on Enable 2 shuts down the second-

ary side while altering the controller duty cycle to near zero.

Externally, the use of either port is transparent to the user

save for minor differences in idle current. (See specification

table).

When operating multiple converters, system requirements

often dictate operation of the converters at a common fre-

quency. To accommodate this requirement, the AFL series

converters provide both a synchronization input and out-

put.

The sync input port permits synchronization of an AFL co-

nverter to any compatible external frequency source oper-

ating between 500 and 700 KHz. This input signal should

be referenced to the input return and have a 10% to 90%

duty cycle. Compatibility requires transition times less th an

100 ns, maximum low level of +0.8 volts and a minimum

high

level of +2.0 volts. The sync output of another converter

which has been designated as the master oscillator pro-

vides a convenient frequency source for this mode of op-

eration. When external synchronization is not indicted, the

sync in pin should be left unconnected thereby permitting

the converter to operate at its’ own internally set frequency.

The sync output signal is a continuous pulse train set at

550 ±50 KHz, with a duty cycle of 15 ±5%. This signal is

referenced to the input return and has been tailored to be

compatible with the AFL sync input port. Transition times

are less than 100 ns and the low level output impedance is

less than 50 ohms. This signal is active when the DC input

voltage is within the specified operating range and the con-

verter is not inhibited. This synch output has adequate

drive reserve to synchronize at least five additional con-

verters. A typical synchronization connection option is il-

lustrated in Figure III.

Power

Input

(Other Converters)

Share Bus

AFL

- Output

Enable 2

+ Output

Return

Trim

Vin

Rtn

Case

Enable 1

Sync Out

Sync In

AFL

- Output

Enable 2

+ Output

Return

Trim

Vin

Rtn

Case

Enable 1

Sync Out

Sync In

AFL

- Output

Enable 2

+ Output

Return

Trim

Vin

Rtn

Case

Enable 1

Sync Out

Sync In

Optional

Synchronization

Connection

to Positive Load

to Negative Load

Figure III. illustrates the preferred connection scheme for

operation of a set of AFL converters with outputs operating

in parallel. Use of this connection permits equal current shar-

ing among the members of a set whose load current ex-

ceeds the capacity of an individual AFL. An important fea-

ture of the AFL series operating in the parallel mode is that

in addition to sharing the current, the stress induced by

temperature will also be shared. Thus if one member of a

paralleled set is operating at a higher case temperature, the

current it provides to the load will be reduced as compensa-

tion for the temperature induced stress on that device.

AFL2805SW/ES Folha de dados(PDF) 6 Page - International Rectifier

AFL2805SW/ES Folha de dados(HTML) 6 Page - International Rectifier

Html Pages

1 2 3 4 5 6 7 8 9 10

Folha de dados Download

Ligação URL