SAM9X60SIP datasheet(2/40 Pages) MICROCHIP

2 / 40 page

Features

• CPU

– ARM926EJ-S Arm Thumb processor running up to 600 MHz

– 32-Kbyte data cache, 32-Kbyte instruction cache, Memory Management Unit (MMU)

• Memories

– One 160-Kbyte internal ROM

• 64-Kbyte internal ROM embedding a secure bootloader program supporting boot on NandFlash,

SDCard, SPI or QSPI Flash. Bootloader features selectable by OTP bits.

• 96-Kbyte ROM for NAND Flash BCH ECC table

– DDR2-SDRAM memory up to 1 Gbit or 64-Mbit SDR-SDRAM memory, 16-bit data bus

– One 64-Kbyte internal SRAM (SRAM0), single-cycle access at system speed

– High Bandwidth Multi-port DDR2/LPDDR Controller (MPDDRC)

– 8-bit External Bus Interface (EBI) supporting 8-bit NAND Flash connected on D16-D23

– NAND Flash Controller, with up to 24-bit Programmable Multi-bit Error Correcting Code (PMECC)

– One 11-Kbyte OTP memory for secure key storage with emulation mode (OTP bits are emulated by a

4-Kbyte SRAM (SRAM1))

• System Running up to 200 MHz

– Power-on Reset cells, Reset Controller, Shutdown Controller, Periodic Interval Timer, Watchdog Timer

running on internal low-power 32-kHz RC and Real Time Clock running on external crystal

– Two internal trimmed RC oscillators: 32 kHz (low-power) and 12 MHz

– Two selectable crystal oscillators: 32.768 kHz (low-power) and 8 to 50 MHz

– One PLL for the system and one PLL optimized for USB high-speed operation (480 MHz)

– One dual-port 16-channel DMA Controller (XDMAC)

– Advanced Interrupt Controller (AIC) and Debug Unit (DBGU)

– JTAG port with disable bit in OTP memory

– Two programmable external clock signals

• Low Power Modes

– Backup mode with RTC, eight 32-bit general purpose backup registers, and Shutdown Controller to control

the external power supply

– Clock Generator and Power Management Controller

– Software-programmable Ultra-Low Power modes: Very Slow Clock Operating Mode (ULP0), and No-Clock

Operating Mode (ULP1) with fast wake-up capabilities

– Software programmable power optimization capabilities

• Peripherals

– LCD Controller with overlay, alpha-blending, rotation, scaling and color conversion. Up to 1024 x 768

resolution

– 2D Graphics Controller supporting Fill BLT, Copy BLT, Transparent BLT, Blend/Alpha BLT, ROP4 BLT

(Raster Operations) and Command Ring Buffer

– ITU-R BT. 601/656, up to 12-bit Image Sensor Interface (ISI)

– One USB Device High Speed, three USB Host High Speed with dedicated On-Chip Transceivers

– Two 10/100 Mbps Ethernet Mac Controller

– Two 4-bit Secure Digital MultiMedia Card Controller (SDMMC)

– Two CAN Controllers

– One Quad I/O SPI Controller

– Two three-channel 32-bit Timer/Counters

– One high resolution (64-bit) Periodic Interval Timer

– One Synchronous Serial Controller

– One Inter-IC Sound (I²S) Multi-Channel Controller (I2SMCC) with TDM support

– One Audio Class D Controller with Single-Ended (SE) or Bridge Tied Load (BTL) connection to power stage

– One four-channel 16-bit PWM Controller

SAM9X60 SIP

and its subsidiaries

Datasheet

DS60001580C-page 2

SAM9X60SIP Folha de dados(PDF) 2 Page - Microchip Technology

SAM9X60SIP Folha de dados(HTML) 2 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Folha de dados Download

Ligação URL