5

Dimensions shown in: mm

Specifications and dimensions subject to change

www.ckswitches.com

PROCESS – CONTACT AND CABLE INSERTION

Cable Crimping

1 – Insert wire into contact body.

2 – Insert the unit into the crimping tool (selector position 2) with dedicated locator.

Crimping tool - Position #2:

M22520/2-01 (P/N: C995-0001-584)

Contact Insertion

Insert contact with wire into rear insulator cavity until positive stop.

To avoid stress onto retention clip, insert contact in the axis (no

insertion angle).

To be sure contact is locked securely, pull back lightly on wire or use

calibrated test retention tool.

MDMA-Retention tool (P/N: C115373-0003).

PROCESS – CONTACT AND CABLE EXTRACTION

1 – Select contact extraction tool:

- Connector size 9 to 37 ->MDMA-Extract tool-01 (P/N: C115373-0006)

- Connector size 51

->MDMA-Extract tool-02 (P/N: C115373-0007)

2 – Insert tool tip into contact cavity until tip bottoms against contact

shoulder, releasing tine.

Hold wire against tool with finger and remove tool and contact.

Be careful to put extraction tool in the good position!

Each contact cavity has flat area to place tool tip.

Insertion area for Extraction tool

Connector size 9 to 37

Insertion area for Extraction tool

Connector size 51

Locator for Male Contact:

MDMA-Locator-P-01 (P/N: C115373-0001)

Locator for Female Contact:

MDMA-Locator-S-01 (P/N: C115373-0002)