DANUBE

http://www.danube.com.tw

2016/09/20

9

 INPUT FUSE SELECTION GUIDE

9-18V

INPUT VOLTAGE(VDC)

18-36V

INPUT VOLTAGE(VDC)

36-75V

INPUT VOLTAGE(VDC)

5000mA Slow-Blow Type

3000mA Slow-Blow Type

1500mA Slow-Blow Type

DC-DC

CONVERTER

+Vin

-Vin

+Vout

-Vout

OUTPUT

Fuse

INPUT

Note: Certain applications may require the installation of external fuse in front of the input.

FEW SERIES APPLICATION NOTES:

EXTERNAL CAPACITANCE REQUIREMENTS:

No external capacitance is required for operation of the FEW series.

External output capacitance is not required for operation; however it is recommended that 10uF

tantalum and 0.1uF ceramic capacitance be selected for reduced system noise.

We Can Offer EMC-Filter According To EN55011/22 Class B.

Negative Outputs:

A negative output voltage may be obtained by connecting the +OUT to circuit ground and

connecting –OUT as the negative output.

Remote ON/OFF:

The remote ON/OFF pin may be left floating if this function is not use. It is recommended to drive this

pin with an open collector arrangement or a relay contact. When the ON/OFF pin is pulled low with

respect to the –VIN, the converter is placed in a low power drain state.

Output TRIM:

The TRIM pin may be used to adjust the output +10% ~ -20% from the nominal setting .this function

allows adjustment for voltage drops in the system wiring. If the TRIM function is not required the pin

may be left floating.

FOR MORE INFORMATION CALL:

Danube Enterprise Co., Ltd.

Tel: 886-7-3755165

Fax: 886-7-3755330

E-mail: danube@ms10.hinet.net

Home Page

http://www.danube.com.tw