16

2-6-3,Nakagawa Chuoh,Tsuzuki-Ku,Yokohama-Shi 224-8540,JAPAN

https://www.hirose.com

　　　　　　

FH69 Series/0.5mm Pitch, 2.3mm Height, Top and Bottom Independent 2-point Contact, 125℃ Heat Resistance FPC/FFC Connector

Precautions

【PCB Layout Precautions】

Design the board layout so that no load is applied to the connector FPC.

・Route the FPC so that it has leeway and is not pulled. Make sure that the reinforcing film is horizontal to the board

surface.

・Do not place interfering components under the FPC.

・Check with the FPC manufacture regarding FPC flexibility.

・When designing the board/ layout, ensure that there is enough space to operate and close the actuator.

・Consult with a Hirose representative about usage of FPC size and shape different from what is recommended.

Load on Reinforcement Film

Load on FPC

Case and Components Interfering

with FPC

No Load on Reinforcement Film

OK

Reinforcement Film (Flat)

Reinforcement Film (Slanted)

Reinforcement Film (Slanted)）

【Board Mounting Precautions】

・Please check the recommended mounting PCB land shape, metal mask opening and FPC. When using a pattern different

from the recommendations, check the mounting condition before use.

・Check the mounting condition before use when there is silk printing below the connector.

・The reflow conditions must be within the specifications. Mounting conditions may be affected by the type of solder paste,

manufacturer, PCB size and other mounted components. Please check the mounting conditions before use.

・Keep board warpage to a minimum. The coplanarity of this connector is 0. 1mm Max. Soldering failure may occur due to

excessive board warpage.

・When mounting the FPC, design a reinforcing plate for easy handling. Reinforcing plates made of glass epoxy with a

thickness of 0. 3mm Min. are recommended.

・Do not apply excessive force to the connector before mounting, such as by pulling the emboss out from the reel or

suctioning the connector from the emboss. ( 0. 5N Max. )