output(mySwitch.getReceivedValue(), mySwitch.getReceivedBitlength(),

mySwitch.getReceivedDelay(),

mySwitch.getReceivedRawdata(),mySwitch.getReceivedProtocol());

mySwitch.resetAvailable();

}

}

Having an Arduino board connected to your computer follow these instructions:

1. Go to the Tools tab

2. Select Arduino UNO board

3. Select the COM port

4. Press the Upload button.

Decoder – Schematics

After uploading the sketch, connect an 433MHz RF receiver to Digital Pin 2 of your

Arduino UNO board:

Decode RF Signals (codes)

Open the Arduino IDE serial monitor and start pressing the buttons. As shown in the

video demonstration below: