PRODUCT DATA SHEET

* DISCLAIMER: Blueshift MAKES NO WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS

FOR A PARTICULAR PURPOSE, COURSE OF PERFORMANCE, OR TRADE USAGE. All of the descriptive information, the typical performance data, and recommendations

for the use of Blueshift products shall be used only as a guide and do not reflect the specification or specification range for any particular property of the product.

Furnishing such information is merely an attempt to assist you after you have indicated your contemplated use and shall in no event constitute a warranty of any kind

by Blueshift. All purchasers of Blueshift products shall be responsible for independently determining the suitability of the material for the purpose for which it is

purchased, and for performing any additional testing that may be necessary to support purchaser’s intended use. No distributor, salesman, or representative of

Blueshift is authorized to give any warranty, guaranty, or make any representation in addition or contrary to the above.

Date Updated: 8/2/2022

5 South Spencer Road

Spencer, MA 01562

United States of America

+1 (888) 350-7586

www.blueshiftmaterials.com

PHYSICAL AND MECHANICAL PROPERTIES

ASTM METHOD

VALUE

UNITS

Thickness

In-house method

240 ± 38 (9.5 ± 1.5)

µm (mil)

Tensile Strength

ASTM D882-12

15 ± 2 (2 ± 0.3)

MPa (ksi)

Young’s Modulus

ASTM D882-12

450 ± 50 (65 ± 7)

MPa (ksi)

Tensile Elongation at Break

ASTM D882-12

8 ± 2

%

Density

In-house method

0.58 ± 0.05

THERMAL PROPERTIES

ASTM METHOD

VALUE

UNITS

Thermal Conductivity (23°C)

ASTM C518-10

0.0046 ± 0.0003

mW/m*K

THERMOMECHANICAL PROPERTIES

ASTM METHOD

VALUE

UNITS

Glass Transition Temperature (AeroZero Tg, DMA)

ASTM E1640-13

305 (580)

°C (°F)

Decomposition Temperature (10 wt% loss, TGA)

ASTM E2550-17

410 (770)

°C (°F)

ADDITIONAL PROPERTIES

ASTM METHOD

VALUE

UNITS

Adhesive strength: 180° peel/3 day-RT dwell time

RockeTape on 2-mil Al foil substrate

ASTM D3330

>200 (1.1)

N/m (lb/in)

UL Flammability Rating

UL94VTM

VTM-0

-

Data within this table are typical values for the listed product. The above data is not intended to indicate product specifications. Actual product specifications are available upon request.

Application

Prepare the surface by removing any loose particles, wipe the surface with isopropyl alcohol and allow to dry. Remove the

release liner from the tape and apply to the surface with adequate finger or mechanical pressure. Standard application

temperature is 25 °C (72 °F) and the minimum application temperature is 10 °C (50 °F). The minimum set time is 24 hours

before performing any tests, with maximum adhesion being reached at 72 hrs. Increasing the temperature and dwell time may

increase adhesion strength.

Blueshift products are manufactured under a certified AS9100D/ISO9001:2015 Quality Management System facility.

For more information on Blueshift Film and Laminate products, please visit our website.