–

–

–

–

6

7

Regulatory Considerations

The handheld transmitter has been tested and conforms to the

requirements of the current Radio Equipment Directive (RED) standards.

The handheld’s test report and Declaration of Conformity (DoC) are

available from Linx Technologies upon request. Reference Guide RG-00111

outlines the test setup and radio configurations that were used in the

testing and certification of this device.

The Handheld Transmitter is an RF transceiver operating in the h1.3 band

(ERC 70-03) using AFA +LBT (Also known as Polite Spectrum Access). It

falls under Equipment Class I (EN 301 489-3 v1.6.1) and Receiver Category

2 (EN 300 220-1 v3.1.1)

It is important to note that the HUM-868-PRO is not declared as an

FHSS system. Rather, it is declared as an RF transceiver using Adaptive

Frequency Agility (AFA). The AFA system uses periodic channel adaptivity

with 70 available channels.

The OTX-868-HH-LR8-PRC transmitter has been tested and conforms to

EN 60950-1:2006 +A11:2009 + A1:2010 + A12:2011 +A2: 2013,

EN 300 220-1 V3.1.1, EN 300 220-2 v3.1.1, EN 301 489-1 V1.9.2, and EN

301 489-3 v1.6.1.

To maintain validity of the Declaration of Conformity (DoC), the transmitter,

including the label, shall not be modified.

The integrator must maintain a copy of the OTX-868-HH-LR8-PRC Data

Guide and ensure that the final product does not exceed the specified

power ratings, antenna specifications, firmware settings, and/or installation

requirements as specified in the data guide.

Depending on the end application, additional testing may be required. The

integrator is solely responsible for ensuring that the final product complies

with all regulatory requirements in the specific country where the end

device is marketed.

All Linx products are designed with the approval process in mind and thus

much of the frustration that is typically experienced with a discrete design

is eliminated. Linx Technologies has aided many customers through the

certification process and we are available to answer any questions and

provide any assistance that is required.

Regulatory Standards Tested

• Operating Frequency - EN 300 220-1 v3.1.1 (2017-02) Section 5.1.2

• Unwanted Emissions in the Spurious Domain - EN 300 220-1 v3.1.1

(2017-02) Section 5.9.2

• Effective Radiated Power - EN 300 220-1 v3.1.1 (2017-02) Section

5.2.2

• Occupied Bandwidth - EN 300 220-1 v3.1.1 (2017-02) Section 5.6.2

• TX out of band Emissions - EN 300 220-1 v3.1.1 (2017-02) Section

5.8.2

• Transient Power - EN 300 220-1 v3.1.1 (2017-02) Section 5.10.2

• TX Behavior under Low Voltage Conditions - EN 300 220-1 v3.1.1

(2017-02) Section 5.12.2

• RX Sensitivity - EN 300 220-1 v3.1.1 (2017-02) Section 5.14.2

• Blocking - EN 300 220-1 v3.1.1 (2017-02) Section 5.14.2

• Clear Channel Assessment Method - EN 300 220-1 v3.1.1 (2017-02)

Section 5.21.2

• Polite Spectrum Access Timing Parameters - EN 300 220-1 v3.1.1

(2017-02) Section 5.21.3

• Adaptive Frequency Agility - EN 300 220-1 v3.1.1 (2017-02) Section

5.21.4

• Indirect ESD, ±2.0 kV and ±4.0 kV (HCP and VCP) - EN 301 489-3

v1.6.1

• Radiated RF EM Field Test - EN301 489-3 v1.6.1

the Radio Equipment Directive (RED). A Declaration of Conformity must

be issued for each standard and kept on file as described in the Radio

Equipment Directive.