MOSFET Power Controller, connect the thing that needs power to the output, then

connect one of the digital outputs of your microcontroller to the input pads. Now

whenever you drive that pin on your controller HIGH, the battery will be connected!

The N-Channel MOSFET used in this design is rated for up to 30V and 6.5A although

the board is really intended to be used at lower power. If you hook up anything

beyond a 3.7V Li-Po battery, proceed at your own risk!

Features:

• Control High-Current Loads

• JST Connector makes Changing Batteries a Snap

• It’s Sewable! (Also has standard 0.1" spaced headers)

Page 2 of 2

8/5/2016

https://www.sparkfun.com/products/11214