After the LEDs blink 3 times the PSE will continue to try to detect a valid load.

Therefore, until the correct load is applied, the LEDs will continue to blink. If there is an

open circuit connected to the output RJ45 then the LEDs will not blink but the PSE will

continue to try to detect a valid load.

Fault Sequence:

Should there be a fault such as an overload or short circuit then all the three LEDs will

blink 5 times in 2 seconds, and then go off as the power supply tries to re-detect a valid

load. If there is a problem in detecting, the LED will indicate what is wrong with the

load as per the codes in the section above.