STP08CDC596 datasheet(9/20 Pages) STMICROELECTRONICS

Nome de Peças	STP08CDC596

Descrição Electrónicos	8-BIT CONSTANT CURRENT LED SINK DRIVER WITH FULL OUTPUT DETECTION

PDF	20 Pages

Scroll/Zoom	100%

Fabricante Electrônico	STMICROELECTRONICS [STMicroelectronics]

Página de início	http://www.st.com

Logo

9 / 20 page

STP08CDC596

9/20

RUNNING THE DETECTION MODE

Phase One: “Entering In Detection Mode”

From the “Normal Mode” condition the device can

switch to the “Error Detection Mode” by a logic

sequence on the OE/DM2 and LE/DM1 pins as

showed in the following Table and Diagram:

Table 9: Entering In Detection Truth Table

Figure 13: Entering In Detection Timing Diagram

After these five CLK cycles the device goes into

the” Error Detection Mode” and at the 6th rise front

of CLK the SDI data are ready for the sampling.

Phase Two: “Error Detection”

The eight data bits must be set “1” in order to set

ON all the outputs during the detection. The data

are latched by LE/DM1 and after that the outputs

are ready for the detection process. When the

Micro controller switches the OE/DM2 to LOW, the

device drives the LEDs in order to analyze if an

OPEN or SHORT condition has occurred.

Figure 14: Detection Diagram

CLK

1°

2°

3°

4°

5°

OE/DM2

LE/DM1

STP08CDC596 Folha de dados(PDF) 9 Page - STMicroelectronics