MODEL: R3-NECT1

R3-NECT1 SPECIFICATIONS

ES-8274 Rev.0 Page 1/4

http://www.m-system.co.jp/

Remote I/O R3 Series

NETWORK INTERFACE MODULE

(EtherCAT)

EtherCAT® is a registered trademark and patented

technology, licensed by Beckhoff Automation GmbH,

Germany.

109

(4.29)

27.5 (1.08)

130

(5.12)

mm (inch)

MODEL: R3-NECT1[1]

ORDERING INFORMATION

• Code number: R3-NECT1[1]

Specify a code from below for [1].

(e.g. R3-NECT1/CE/Q)

• Specify the specification for option code /Q

(e.g. /C01)

[1] OPTIONS (multiple selections)

Standards & Approvals

blank: Without CE

/CE: CE marking

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

RELATED PRODUCTS

• PC configurator software (model: R3CON)

• ESI file

The configurator software and ESI files are downloadable at

M-System’s web site.

Use a commercially available Mini-B USB cable to connect

the unit to a PC.

GENERAL SPECIFICATIONS

Connection

EtherCAT: RJ-45 Modular Jack

Internal bus: Via the Installation Base (model: R3-BSx)

Internal power: Via the Installation Base (model: R3-BSx)

RUN contact output: M3 separable screw terminal (torque

0.5 N·m)

Screw terminal: Nickel-plated steel

Isolation: EtherCAT to internal bus or internal power to RUN

contact output

Input error data setting: Input value setting at input module

error with side DIP SW

Dual communication setting: Set with the side DIP switch

Status indicators: RUN, ERR, L/A IN, L/A OUT

(Refer to the instruction manual.)

■ RUN CONTACT OUTPUT

RUN contact: Turns ON while the green RUN LED is ON (ON

in normal operation).

Rated load: 250 V AC @ 0.5 A (cos ø = 1)

30 V DC @ 0.5 A (resistive load)

(Less than 50 V AC to conform with EU Directive)

Maximum switching voltage: 250 V AC or 30 V DC

Maximum switching power: 250 VA or 150 W

Minimum load: 1 V DC @ 1 mA

When driving an inductive load, external contact protection

and noise quenching recommended.

EtherCAT COMMUNICATION

Standard: IEEE 802.3u

Transmission type: 100BASE-TX

Transmission speed: Full-duplex 100 Mbps

Transmission media: 100BASE-TX (STP cable; Category 5e)

Maximum segment length: 100 meters

Fixed address: Set with rotary switches

(The master must support MDP.)

INSTALLATION

Current consumption: 100 mA

Operating temperature: -10 to +55°C (14 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Installation Base (model: R3-BSx)

Weight: 170 g (0.37 lb)

PERFORMANCE

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 1500 V AC @ 1 minute (EtherCAT to

internal bus or internal power to RUN contact output)

1500 V AC @ 1 minute (power input to FG; isolated on the

power supply module)