MODEL: R3-NEIP1

R3-NEIP1 SPECIFICATIONS

ES-8466 Rev.6 Page 1/6

https://www.m-system.co.jp/

Remote I/O R3 Series

EtherNet/IP INTERFACE MODULE

Functions & Features

• Converts analog and discrete I/O data to the open network

fieldbus (EtherNet/IP)

Typical Applications

• Remote I/O for DCS and PLC

109

[4.29]

27.5 [1.08]

130

[5.12]

mm [inch]

MODEL:R3–NEIP1[1]

ORDERING INFORMATION

• Code number: R3-NEIP1[1]

Specify a code from below for [1].

(e.g. R3-NEIP1/CE/Q)

• Specify the specification for option code /Q

(e.g. /C01)

[1] OPTIONS (multiple selections)

Standards & Approvals

blank: Without CE

/CE: CE marking

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

RELATED PRODUCTS

• PC configurator software (model: R3CON)

• EDS file

The EDS file and configurator software are downloadable at

M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

GENERAL SPECIFICATIONS

Connection

Ethernet: RJ-45 Modular Jack

Internal bus: Via the Installation Base (model: R3-BSx)

Internal power: Via the Installation Base (model: R3-BSx)

RUN contact output: M3 separable screw terminal (torque

0.5 N·m)

Screw terminal: Nickel-plated steel

Isolation: EtherNet/IP to internal bus or internal power to

RUN contact output

Input error data setting: Input value setting at input module

error with side DIP SW

Dual communication setting: Set with the side DIP switch

Data allocation setting: Set with the side DIP switch

■ RUN CONTACT OUTPUT

RUN contact: Turns ON when both MS and NS LEDs are

green (EtherNet/IP in normal communication).

Rated load: 250 V AC @ 0.5 A (cos ø = 1)

30 V DC @ 0.5 A (resistive load)

(Less than 50 V AC to conform with EU Directive)

Maximum switching voltage: 250 V AC or 30 V DC

Maximum switching power: 250 VA or 150 W

Minimum load: 1 V DC @ 1 mA

When driving an inductive load, external contact protection

and noise quenching recommended.

EtherNet/IP COMMUNICATION

Communication Standard: IEEE 802.3u

Transmission: 10BASE-T, 100BASE-TX

Baud rate: 10/100 Mbps (Auto Negotiation function)

Max. number of socket connections: 3

Connection type: Exclusive owner, Listen only, Input only

Protocol: EtherNet/IP

Transmission media: 10BASE-T (STP, Category 5)

100BASETX (STP, Category 5e)

Max. length of fieldbus segment: 100 meters

IP address: 192.168.0.1 (factory setting); Selectable with PC

Configurator Software (model: R3CON)

BOOTP and DHCP available

Port No.: 44818

I/O data area size: Input and output data area size set with

side DIP SW

Required data words:

Input: 35, 67, 131, 252 words

Output: 35, 67, 131, 252 words (3 words are used only for