Germany: +49 621 776 4411

Pepperl+Fuchs Group

Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.

USA: +1 330 486 0001

Singapore: +65 6779 9091

www.pepperl-fuchs.com

fa-info@us.pepperl-fuchs.com

fa-info@sg.pepperl-fuchs.com

fa-info@de.pepperl-fuchs.com

Retroreflective sensor

OBG5000-R101-2EP-IO

3

Teach-in:

Use the rotary switch to select the required operating mode: Normal mode (N) or contrast level I – III.

To teach in a threshold or activate an operating mode, press the "TI" button until the yellow and green LEDs flash in phase (approx. 1 s).

Release the "TI" button. Teach-in starts.

Successful teach-in is indicated by alternating flashing (2.5 Hz) of the yellow and green LEDs. The sensor will now operate in the selected

operating mode with the taught-in threshold.

An unsuccessful teach-in is indicated by rapidly alternating flashing (8 Hz) of the yellow and green LEDs. After an unsuccessful teach-in, the

sensor continues to operate with the previous valid setting after the relevant visual fault signal is issued.

Every taught-in switching threshold can be re-taught (overwritten) by pressing the "TI" button again.

Note: To ensure that the device functions reliably in Contrast mode, the device must be powered on at least 30 s before Teach-in.

Setting the Device to Maximum Sensitivity

Use the rotary switch to select the Normal mode (N) position.

Press the "TI" button for > 4 s. The yellow and green LEDs will go out.

Release the "TI" button.

The settings will be reset to maximum sensitivity. After successfully resetting, the yellow and green LEDs will flash alternately (2.5 Hz).

Switching between light on/dark on

Use the rotary switch to select the light on/dark on (L/D) position.

Press the "TI" button for > 1 s.

The respective operating indicator LED (L/D) will illuminate green and the switching type will change.

To reset the switching type, press the "TI" button for > 4 s.

The respective operating indicator LED (L/D) will illuminate green and the operating indicator will be reset to the most recently active switching

Mass

approx. 36 g

Cable length

2 m

Approvals and certificates

UL approval

E87056 , cULus Listed , class 2 power supply , type rating 1

Curves/Diagrams

Settings

X

Offset Y [mm]

Distance X [m]

Characteristic response curve

0

1

2

3

4

5

6

7

H85-2

C110-2

FE-RR1

VR10

OFR-100/100

150

100

50

0

-50

-100

-150

X

Reflector type:

Stability control > 2

Stability control < 2

Stability control

Distance X [m]

Relative received light strength in switch position "N"

H85-2

C110-2

FE-RR1

100

10

1

2

0

1

2

3

4

5

6

7

6.4 m

6.8 m

4.8 m

VR10

2.8 m

0 m

0 m

0 m

0 m

OFR-100/100

2.2 m

0 m

1.7 m

2.3 m

4.0 m

5.6 m

5.6 m

H85-2

C110-2

FE-RR1

VR10

OFR-100/100